Adopt four-column and three-plate structure, the vertical accuracy of the movable plate is controlled by four precise graphite guide sleeves, and the parallel accuracy of any point of the lower working face and the upper working face is less than 0.1mm.

Two-hand emergency button protection, photoelectric protection;

Maintenance: the oil pressure system and the industrial control part and the fuselage are set independently, so the maintenance is simple, convenient and fast.

The machine adopts PLC control system to cooperate with the self-developed oil circuit board system, so as to accurately control the operation of the machine, which is simple and easy to control.

This series of hydraulic press machine is suitable for moldable materials, such as stamping, bending, flanging, sheet drawing, etc. In addition, it can also be used for correction, pressing, molding of powder products and pressing of non-metallic materials.

This small hydraulic press can use ordinary motors or servo motors. When producing products:

1. If the product is produced by hot press molding, the motor will stop when the molding time is relatively long. It is recommended to use an ordinary motor (lower cost).

2. For hydraulic stamping products, it is recommended to use a servo motor system. The servo motor system has no noise and stable performance. The motor can save 30% of power when the motor is running continuously. Fast and slow speed can be adjusted freely.